2022 Alfa Romeo Giulia 2.0L Turbocharged Inline-4 (GME) Oil Specifications

Viscosity

0W-30

OEM Spec / API

API SN PLUS, ACEA C3

Capacity

5.5 quarts

Oil Filter

Mopar 04892339AA

🔧 Get These Specs On Your Phone

Download OilFinderPro for offline access and oil change reminders

Download Free App

Complete Oil Specifications

Your 2022 Alfa Romeo Giulia with the 2.0T GME engine requires 0W-30 full synthetic oil meeting ACEA C3 and FCA MS-12633 (or API SN PLUS). This Ferrari-derived turbocharged four-cylinder is the heart of the Giulia lineup and demands a precisely specified lubricant — not any generic 0W-30.

Important — Digital Dipstick: The 2022 Giulia uses an electronic oil level sensor, not a traditional dipstick. After an oil change, fill to 5.5 quarts, start the engine, let it idle for 30 seconds, then shut off and wait 2 minutes before checking the digital readout. Top up to the indicated level if needed — do not exceed 5.7 quarts or you risk an overfill warning.

Quick Reference

Specification Value
Viscosity 0W-30
API Rating API SN PLUS, ACEA C3
Capacity (with filter) 5.5–5.7 quarts (see note above)
Oil Filter Mopar 04892339AA
Normal Interval 10000 miles

Why 0W-30 and ACEA C3 for the GME Turbo

The Giulia’s 2.0T GME engine uses a twin-scroll turbocharger and high-pressure direct injection operating at up to 200 bar. Alfa Romeo specifies ACEA C3 — a mid-SAPS (sulphated ash, phosphorus, sulphur) category — because the catalytic converter and diesel particulate filter hardware is sensitive to high-ash oils. The 0W-30 viscosity provides the correct balance: quick cold-start flow for the turbo bearings and adequate high-temperature film strength on the piston rings.

Using incorrect oil will:

  • ❌ Deposit excessive ash on piston rings and turbo bearings from high-SAPS oils
  • ❌ Reduce turbo bearing life if viscosity is too low (e.g. 0W-20) at operating temperature
  • ❌ Trigger the oil quality sensor to shorten intervals unnecessarily

Alfa Romeo-Approved Oil Brands

  • ✅ Pennzoil Ultra Platinum Full Synthetic 0W-30 (FCA MS-12633)

  • ✅ Mobil 1 ESP Full Synthetic 0W-30 (ACEA C3)

  • ✅ Castrol Edge Professional 0W-30 (ACEA C3)

  • ✅ Shell Helix Ultra ECT C3 0W-30

  • ✅ Total Quartz INEO ECS 0W-30 (ACEA C3)

Oil must carry ACEA C3 certification and meet FCA MS-12633 or equivalent. Standard API SN/SP oils without the ACEA C3 rating do not meet Giulia specifications even if the viscosity matches.

Severe Service Check

Use the 5000-mile interval if you:

  • Drive aggressively or use track/sport modes frequently
  • Operate regularly in urban stop-and-go traffic
  • Experience temperatures below −4°F or above 104°F regularly
  • Tow or carry sustained high loads

Installation Details

Drain Plug Torque: 15 ft-lbs
The Giulia drain plug torque is unusually low at 15 ft-lbs (20 Nm). Always replace the copper crush washer — overtightening will strip the aluminum oil pan threads.

OEM Filter: Mopar 04892339AA

Aftermarket Filters:

  • Mobil 1 M1-113A

  • WIX 57502

  • Mahle OC1081

Pro Tip: The oil filter housing on the GME engine is accessed from the top of the engine bay on the passenger side. Use a 27mm oil filter cap socket — the housing torques to 18 ft-lbs.


FAQs

What oil does a 2022 Alfa Romeo Giulia 2.0T take?
0W-30 full synthetic meeting ACEA C3 and FCA MS-12633. Do not use standard API SP without the ACEA C3 rating.

How many quarts does the Giulia 2.0T need?
Start with 5.5 quarts, then verify via the digital oil level display. Maximum fill is 5.7 quarts.

Can I use 0W-20 instead of 0W-30?
No. The GME turbo’s bearing clearances and high operating temperatures require the 30-weight base viscosity. Using 0W-20 risks inadequate film strength.

Is synthetic oil required?
Yes, full synthetic only. Conventional or synthetic-blend oils will not meet ACEA C3 standards.

Why is the drain plug torque so low compared to other cars?
The Giulia uses an aluminum oil pan with a fine-thread drain plug. 15 ft-lbs (20 Nm) is the manufacturer specification — exceeding it risks stripping the pan threads permanently.

How often should I change the oil?
Every 10000 miles or as indicated by the Oil Condition Monitor in the instrument cluster, whichever comes first.


Need these specs on your phone? Download OilFinderPro app for offline access and oil change reminders.

Last verified: 2026-04-12 | Source: 2022 Alfa Romeo Giulia Owner’s Manual

Disclaimer: The information on this page is provided for general reference purposes only. Specifications may be outdated or inaccurate. Always verify oil type, capacity, and service intervals in your vehicle's official owner's manual before performing maintenance.