2023 Buick Envision 2.0L Turbocharged Inline-4 (LSY) Oil Specifications

Viscosity

0W-20

OEM Spec / API

API SP, GM dexos1 Gen3

Capacity

5.3 quarts

Oil Filter

AC Delco PF64

🔧 Get These Specs On Your Phone

Download OilFinderPro for offline access and oil change reminders

Download Free App

Complete Oil Specifications

Your 2023 Buick Envision with the 2.0T LSY engine requires 0W-20 full synthetic oil meeting GM dexos1 Gen3 and API SP / ILSAC GF-6A. The LSY turbocharged four-cylinder is GM’s workhorse compact engine, providing a balance of performance and efficiency in the Envision’s premium compact crossover package.

Quick Reference

Specification Value
Viscosity 0W-20
API Rating API SP, GM dexos1 Gen3
ILSAC Rating GF-6A
Capacity (with filter) 5.3 quarts
Oil Filter AC Delco PF64
Normal Interval 7500 miles

Why dexos1 Gen3 for the LSY Turbo

The LSY uses Gasoline Direct Injection (GDI) and an automatic stop/start system that cycles the engine repeatedly in urban driving — each restart is a cold start for the turbo bearings. dexos1 Gen3 is specifically formulated to resist the fuel dilution that GDI engines are prone to, and provides enhanced Low-Speed Pre-Ignition (LSPI) protection. The stop/start cycling also makes oxidation stability critical — Gen3 oils maintain their protective properties through far more thermal cycles than conventional oils.

Using incorrect oil will:

  • ❌ Increase LSPI risk from fuel dilution in the GDI combustion chamber
  • ❌ Accelerate oil oxidation from stop/start cycling
  • ❌ Void the Buick powertrain warranty (dexos1 approval required)

Buick-Approved Oil Brands

  • ✅ ACDelco dexos1 Gen3 Full Synthetic 0W-20

  • ✅ Mobil 1 dexos1 Gen3 Full Synthetic 0W-20

  • ✅ Pennzoil Platinum dexos1 Gen3 Full Synthetic 0W-20

  • ✅ Castrol Edge dexos1 Gen3 Full Synthetic 0W-20

  • ✅ Valvoline Modern Engine Full Synthetic dexos1 0W-20

Look for the dexos1 Gen3 approval mark on the label. dexos1 Gen2 oils do not meet the 2023 Envision’s specification.

Severe Service Check

Use the 3750-mile interval if you:

  • Drive primarily in urban stop-and-go traffic (exacerbates fuel dilution and stop/start cycling)
  • Make frequent short trips under 5 miles
  • Tow or carry heavy loads regularly
  • Operate in extreme cold below 0°F

Installation Details

Drain Plug Torque: 18 ft-lbs

OEM Filter: AC Delco PF64

Aftermarket Filters:

  • Mobil 1 M1-113A

  • WIX 57502

  • K&N HP-1017

Pro Tip: The GM Oil Life System in the Envision calculates change intervals based on engine revolutions, temperature cycles, and load — it is more accurate than a fixed mileage schedule. Trust the indicator, but treat 7,500 miles as the maximum regardless of what it shows.


FAQs

What oil does a 2023 Buick Envision take?
0W-20 full synthetic with GM dexos1 Gen3 approval.

How many quarts does the Envision 2.0T need?
5.3 quarts with a new filter, 5.0 without.

What’s the difference between dexos1 Gen2 and Gen3?
Gen3 adds enhanced LSPI protection and improved fuel dilution resistance — both critical for the LSY’s direct injection and stop/start system. Use Gen3 in the 2023 Envision.

Is synthetic oil required?
Yes. dexos1 Gen3 requires full synthetic formulation.

How often should I change the oil?
Every 7500 miles maximum. The GM Oil Life System may prompt earlier based on your driving conditions.


Need these specs on your phone? Download OilFinderPro app for offline access and oil change reminders.

Last verified: 2026-04-12 | Source: 2023 Buick Envision Owner’s Manual

Disclaimer: The information on this page is provided for general reference purposes only. Specifications may be outdated or inaccurate. Always verify oil type, capacity, and service intervals in your vehicle's official owner's manual before performing maintenance.