Complete Oil Specifications
Your 2023 Infiniti QX60 with the 3.5L VQ35DD V6 requires 0W-20 full synthetic oil meeting API SP / ILSAC GF-6A. The VQ35DD is a naturally aspirated, direct-injection V6 that powers one of Infiniti’s most popular three-row luxury SUVs.
Quick Reference
| Specification | Value |
|---|---|
| Viscosity | 0W-20 |
| API Rating | API SP |
| ILSAC Rating | GF-6A |
| Capacity (with filter) | 5.1 quarts |
| Oil Filter | Infiniti/Nissan 15208-65F0A |
| Normal Interval | 5000 miles |
Why 0W-20 Is Critical for the VQ35DD
The VQ35DD uses Nissan’s Direct Injection Gasoline (DIG) system with variable valve timing on both intake and exhaust camshafts. These VVEL (Variable Valve Event and Lift) actuators depend on rapid oil pressurization at startup. 0W-20’s low cold-start viscosity reaches the cam phasers within seconds of ignition, while still maintaining a protective film at operating temperature.
Using incorrect oil will:
- ❌ Starve VVEL actuators of pressure during cold starts, accelerating cam phaser wear
- ❌ Increase fuel economy penalty — thicker oil forces the engine to work harder
- ❌ Risk voiding Infiniti’s powertrain warranty
Infiniti-Approved Oil Brands
-
✅ Infiniti Genuine Motor Oil 0W-20
-
✅ Mobil 1 Extended Performance 0W-20
-
✅ Pennzoil Ultra Platinum Full Synthetic 0W-20
-
✅ Castrol Edge Full Synthetic 0W-20
-
✅ Valvoline Advanced Full Synthetic 0W-20
All third-party oils must carry the API SP certification with the ILSAC GF-6A starburst. The GF-6A standard specifically addresses Low-Speed Pre-Ignition (LSPI) protection relevant to DIG engines.
Severe Service Check
Use the 3750-mile interval if you:
- Drive mostly short trips under 5 miles where the engine rarely reaches full operating temperature
- Frequently tow or carry maximum passenger/cargo loads
- Operate in extreme temperatures — desert heat or below-freezing winters
- Drive on dusty or unpaved roads regularly
Installation Details
Drain Plug Torque: 25 ft-lbs
The VQ35DD uses an aluminum oil pan — do not exceed torque spec or use an impact wrench.
OEM Filter: Infiniti/Nissan 15208-65F0A
Aftermarket Filters:
-
Mobil 1 M1-108A
-
WIX 57356XP
-
K&N HP-1008
Pro Tip: The QX60 oil filter is located on the passenger side of the engine. Access from underneath is easier with the engine undershield removed — two screws at the front edge.
FAQs
What oil does a 2023 Infiniti QX60 take?
0W-20 full synthetic meeting API SP / ILSAC GF-6A.
How many quarts does the QX60 3.5L need?
5.1 quarts with a new filter, 4.8 without.
Can I use 5W-20 instead of 0W-20?
No. Infiniti specifies 0W-20 for optimal cold-start protection in the VQ35DD’s direct-injection system. Use 0W-20 unless 0W-20 is unavailable and only as a temporary measure.
Is synthetic oil required?
Yes. The QX60 3.5L requires full synthetic to meet the API SP / GF-6A standard and achieve its 5,000-mile service interval.
How often should I change the oil?
Every 5000 miles for normal driving. Infiniti’s Intelligent Maintenance System will also prompt you based on driving conditions.
Need these specs on your phone? Download OilFinderPro app for offline access and oil change reminders.
Last verified: 2026-04-12 | Source: 2023 Infiniti QX60 Owner’s Manual