2023 Jeep Renegade 1.3L MultiAir Turbocharged I4 (FireFly) Oil Specifications

Viscosity

0W-20

OEM Spec / API

SN Plus

Capacity

4.8 quarts

Oil Filter

Mopar 68439517AA

🔧 Get These Specs On Your Phone

Download OilFinderPro for offline access and oil change reminders

Download Free App

Complete Oil Specifications

Your 2023 Jeep Renegade 1.3L Turbo requires 0W-20 full synthetic oil meeting Stellantis/Mopar specification MS-13340. The FireFly engine is a small-bore aluminum turbocharged four-cylinder developed by FCA (now Stellantis) and shared across the Renegade, Compass, and Cherokee lineup.

Quick Reference

Specification Value
Viscosity 0W-20
API Rating SN Plus
ILSAC Rating GF-6A
Capacity (with filter) 4.8 quarts
Oil Filter Mopar 68439517AA
Normal Interval 10000 miles

Why 0W-20 is Critical for This Engine

The 1.3L FireFly is a high-specific-output turbocharged engine — it produces 177 horsepower from just 1.3 liters. This translates to extremely high combustion pressures on small cylinder bores. Mopar’s MS-13340 specification requires 0W-20 with specific anti-wear additives that protect the small aluminum cylinder bore lining from micro-scuffing at high power density. The ultra-low viscosity also allows the MultiAir electro-hydraulic valve actuation system to cycle correctly at cold temperatures.

Using incorrect oil will:

  • ❌ Impair MultiAir electro-hydraulic valve actuation, causing rough idle and loss of power
  • ❌ Increase bore wear from inadequate anti-wear chemistry in non-MS-13340 oils
  • ❌ Risk turbocharger bearing failure if high-SAPS oil clogs small oil galleries

Jeep-Approved Oil Brands

  • ✅ Mopar Full Synthetic Motor Oil 0W-20 (MS-13340)

  • ✅ Pennzoil Platinum Full Synthetic 0W-20

  • ✅ Shell Helix Ultra 0W-20

  • ✅ Mobil 1 Advanced Full Synthetic 0W-20

  • ✅ Castrol Edge 0W-20 Advanced Full Synthetic

Severe Service Check

You need the 5000-mile interval if you:

  • Drive mostly short trips under 5 miles in urban environments
  • Experience sustained extreme cold (below -20°F) with frequent short trips
  • Drive in heavy stop-and-go traffic daily
  • Tow a small trailer or carry maximum payload regularly

Installation Details

Drain Plug Torque: 15 ft-lbs ⚠️ The FireFly engine uses a very low drain plug torque (15 ft-lbs) due to the lightweight aluminum oil pan. Do NOT overtighten — stripped pan threads on this engine require pan replacement.

OEM Filter: Mopar 68439517AA

Aftermarket Filters:

  • Fram CH10358

  • Wix 57060

  • Mobil 1 M1-113A

Pro Tip: The Renegade’s 1.3T oil drain plug faces directly down and can be difficult to reach cleanly without a flexible extension on your ratchet. Use a drain pan with a wide catch area as the pan sits close to the subframe.


FAQs

What oil does a 2023 Jeep Renegade 1.3T take? 0W-20 full synthetic oil meeting Mopar specification MS-13340 and API SN Plus.

How many quarts does it need? 4.8 quarts with a new filter, 4.3 quarts without.

Can I use 0W-30 instead of 0W-20 in the Renegade? No — the Renegade 1.3T specifies 0W-20 per Mopar MS-13340. 0W-30 is not listed as an approved substitute for the US-market Renegade.

Is synthetic oil required? Yes — full synthetic is required to meet MS-13340 and achieve the 10,000-mile service interval.

How often should I change the oil? Every 10000 miles for normal driving, every 5000 miles under severe conditions.


Need these specs on your phone? Download OilFinderPro app for offline access and oil change reminders.

Last verified: 2026-03-31 | Source: 2023 Jeep Renegade Owner’s Manual

Disclaimer: The information on this page is provided for general reference purposes only. Specifications may be outdated or inaccurate. Always verify oil type, capacity, and service intervals in your vehicle's official owner's manual before performing maintenance.