2022 Citroen C3 1.2L PureTech 110 Turbocharged 3-Cylinder (EB2ADTS) Oil Specifications

Viscosity

5W-30

OEM Spec / API

PSA B71 2312 / ACEA C2

Capacity

4.0 quarts

Oil Filter

Citroën 1109.CK

🔧 Get These Specs On Your Phone

Download OilFinderPro for offline access and oil change reminders

Download Free App

Complete Oil Specifications

Your 2022 Citroën C3 1.2 PureTech 110 requires 5W-30 low-SAPS full synthetic oil meeting the PSA B71 2312 specification and ACEA C2 standard.

Quick Reference

Specification Value
Viscosity 5W-30
PSA Standard PSA B71 2312 / ACEA C2
Capacity (with filter) 4.0 quarts
Oil Filter Citroën 1109.CK
Normal Interval 12000 miles or 1 year

Why 5W-30 PSA B71 2312 Is Essential

The EB2ADTS is a turbocharged 3-cylinder with a wet timing belt — the belt runs submerged in engine oil rather than in a dry enclosure. This design requires low-SAPS (reduced sulphated ash, phosphorus, sulphur) chemistry to prevent belt material degradation. PSA B71 2312 oils are specifically validated for this wet-belt architecture and protect the belt throughout the full service interval.

Using incorrect oil will:

  • ❌ Accelerate wet timing belt degradation, risking catastrophic belt failure
  • ❌ Clog the gasoline particulate filter (GPF) with excess ash deposits
  • ❌ Cause premature turbocharger bearing wear at high engine temperatures

Citroën-Approved Oil Brands

  • ✅ Total Quartz Ineo EcoB 5W-30 (PSA B71 2312)

  • ✅ Castrol Edge 5W-30 C2

  • ✅ Shell Helix Ultra ECT C2 5W-30

  • ✅ Mobil 1 ESP Formula 5W-30

  • ✅ Liqui Moly Special Tec F 5W-30

Confirm the label shows PSA B71 2312 or ACEA C2 — both designations indicate the correct low-SAPS formulation for this engine.

Severe Service Check

You need the 6000-mile interval if you:

  • Drive predominantly short urban trips under 5 miles
  • Frequently idle in stop-and-go city traffic
  • Experience regular cold starts in temperatures below 14°F (−10°C)
  • Drive in dusty conditions

Installation Details

Drain Plug Torque: 15 ft-lbs (20 Nm)
Replace the aluminium drain plug washer at every oil change — it is a single-use sealing ring.

OEM Filter: Citroën 1109.CK

Aftermarket Filters:

  • Mann-Filter HU 712/7 x

  • Bosch 1 457 429 114

  • Mahle OC 467

Pro Tip: The 1.2 PureTech holds very little oil — add carefully and check the dipstick after each 0.5-quart increment to avoid overfilling. The filter is accessible from above on the EB2ADTS, making DIY oil changes straightforward.


FAQs

What oil does a 2022 Citroën C3 1.2 PureTech take?
5W-30 full synthetic oil meeting PSA B71 2312 and ACEA C2 specifications.

How many quarts does it need?
4.0 quarts with a new filter, 3.7 without.

Can I use 5W-40 instead of 5W-30?
No. The wet timing belt and GPF require the low-SAPS formulation in PSA B71 2312. A 5W-40 oil typically carries ACEA A3/B4 classification with higher SAPS content that is incompatible with this engine.

Is the timing belt the same as a cam belt?
Yes — and unlike most timing belts, the PureTech’s belt runs in an oil bath. This extends belt life but makes the correct oil specification mandatory, not optional.

How often should I change the oil?
Every 12,000 miles or 1 year for normal driving. Every 6,000 miles or 6 months for predominantly urban or short-trip driving.


Need these specs on your phone? Download OilFinderPro app for offline access and oil change reminders.

Last verified: 2026-05-21 | Source: 2022 Citroën C3 Owner’s Manual

Disclaimer: The information on this page is provided for general reference purposes only. Specifications may be outdated or inaccurate. Always verify oil type, capacity, and service intervals in your vehicle's official owner's manual before performing maintenance.