Complete Oil Specifications
Your 2024 Hyundai Palisade 3.8L V6 requires 5W-30 full synthetic oil meeting API SP and ILSAC GF-6A standards. The Lambda III V6 is a naturally aspirated engine with Gasoline Direct Injection and Continuously Variable Valve Timing (CVVT) on both intake and exhaust camshafts, making quality oil viscosity important for CVVT actuator response.
Quick Reference
| Specification | Value |
|---|---|
| Viscosity | 5W-30 |
| API Rating | SP |
| ILSAC Rating | GF-6A |
| Capacity (with filter) | 6.9 quarts |
| Oil Filter | Hyundai 26320-3C30A |
| Normal Interval | 7500 miles |
Why 5W-30 is Critical for This Engine
The Lambda III 3.8L GDI V6 is tuned for towing and family hauling in a three-row SUV. Hyundai specifies 5W-30 over lower viscosities because the engine operates under sustained mid-range load where oil film thickness is critical for bearing protection. The 5W cold-start rating also ensures adequate pump-up of the CVVT hydraulic system in winter conditions.
Using incorrect oil will:
- ❌ Cause delayed CVVT actuation, reducing low-end torque and causing rough cold idle
- ❌ Thin out under sustained towing loads if a lighter viscosity is used
- ❌ Fail to meet API SP wear protection requirements if non-certified oil is used
Hyundai-Approved Oil Brands
-
✅ Hyundai Genuine Motor Oil 5W-30 Full Synthetic
-
✅ Mobil 1 Extended Performance 5W-30
-
✅ Castrol EDGE Full Synthetic 5W-30
-
✅ Pennzoil Platinum Full Synthetic 5W-30
-
✅ Valvoline Full Synthetic 5W-30
Look for the API SP certification starburst on the bottle. Hyundai’s service manual specifies API SP as the minimum standard for the Lambda III engine.
Severe Service Check
You need the 5000-mile interval if you:
- Tow a boat, camper, or trailer near the Palisade’s rated capacity
- Drive predominantly in city stop-and-go traffic
- Regularly carry 6–8 passengers with luggage
- Operate in extreme heat or cold climates
Installation Details
Drain Plug Torque: 32 ft-lbs
The Palisade drain plug uses an aluminum gasket — replace it at each oil change to prevent seepage.
OEM Filter: Hyundai 26320-3C30A
Aftermarket Filters:
-
Denso 150-2003
-
Mann HU 718/5 x
-
WIX WL10290
Pro Tip: The 3.8L V6 holds nearly 7 quarts — verify with the dipstick after filling rather than assuming the full capacity was required after each drain.
FAQs
What oil does a 2024 Hyundai Palisade 3.8L V6 take? 5W-30 full synthetic oil meeting API SP and ILSAC GF-6A standards.
How many quarts does it need? 6.9 quarts with a new filter, 6.5 without.
Can I use 0W-20 instead of 5W-30? No. Hyundai specifies 5W-30 for the Lambda III V6. Using a lighter viscosity may reduce oil film thickness under sustained load.
Is synthetic oil required? Hyundai recommends full synthetic oil for the Lambda III V6 to meet API SP requirements.
How often should I change the oil? Every 7500 miles for normal driving, or 5000 miles for towing and severe service.
Need these specs on your phone? Download OilFinderPro app for offline access and oil change reminders.
Last verified: 2026-05-31 | Source: 2024 Hyundai Palisade Owner’s Manual