Complete Oil Specifications
Your 2024 Toyota Tundra equipped with the 3.5L Twin-Turbocharged V6 (V35A-FTS) requires 0W-20 full synthetic oil meeting API SP and ILSAC GF-6A standards.
Quick Reference
| Specification | Value |
|---|---|
| Viscosity | 0W-20 |
| API Rating | API SP |
| ILSAC Rating | GF-6A |
| Capacity (with filter) | 7.1 quarts |
| Oil Filter | Toyota 04152-YZZA3 |
| Normal Interval | 10000 miles |
Why 0W-20 is Critical for This Engine
The V35A-FTS twin-turbo V6 replaced Toyota’s long-running 5.7L V8 in the third-generation Tundra. This direct-injected, twin-turbocharged engine uses D-4ST dual injection and Toyota’s multi-hole injector technology to deliver V8-class torque from a smaller displacement. Both turbochargers share an oil-cooled center housing that requires immediate lubrication on every cold start — 0W-20’s low cold-viscosity rating ensures oil reaches those bearings in seconds rather than minutes.
The V35A-FTS also features Toyota’s Multi-Stage Hybrid system on iForce Max variants, placing additional thermal demand on the oil during towing cycles.
Using a heavier oil will:
- ❌ Delay oil delivery to the twin turbocharger bearings during cold starts
- ❌ Increase pumping losses on the high-compression direct injection system
- ❌ Accelerate wear on the variable valve timing (VVT-iE) electric actuator on the intake camshaft
Toyota-Approved Oil Brands
-
✅ Toyota Genuine Motor Oil 0W-20
-
✅ Mobil 1 Advanced Fuel Economy 0W-20
-
✅ Castrol Edge Full Synthetic 0W-20
-
✅ Pennzoil Platinum Full Synthetic 0W-20
Verify the API SP donut and ILSAC GF-6A starburst appear on the container. Full synthetic is required — the V35A-FTS does not tolerate conventional oil at 10,000-mile intervals.
Severe Service Check
You need the 5000-mile interval if you:
- Regularly tow near or at the Tundra’s rated maximum tow capacity
- Use the truck for frequent off-road driving in dusty or muddy conditions
- Make repeated trailer starts on steep grades (sustained high-RPM turbo operation)
- Operate consistently in temperatures above 100°F or below -20°F
Installation Details
Drain Plug Torque: 33 ft-lbs Replace the aluminum crush washer (Toyota 90430-12031) at every service. The V35A-FTS drain plug is on the driver’s rear of the oil pan — easier access than the previous 5.7L V8.
OEM Filter: Toyota 04152-YZZA3
Aftermarket Filters:
-
Mobil 1 M1C-251A
-
WIX 57256
-
K&N PS-7024
Pro Tip: The V35A-FTS uses a cartridge-style filter housing. A 64mm cap wrench is required. Torque the housing cap to 18 ft-lbs after installing a fresh cartridge. Pre-fill the cartridge before installation to minimize the dry-start window after the oil change.
FAQs
What oil does a 2024 Toyota Tundra 3.5L take? 0W-20 full synthetic oil meeting API SP and ILSAC GF-6A standards.
How many quarts does it need? 7.1 quarts with a new filter, 6.9 without.
Does the 2024 Tundra take the same oil as the 2022/2023? Yes — all third-generation Tundra V35A-FTS engines (2022–present) use 0W-20 API SP with the same 7.1 qt capacity and filter (04152-YZZA3).
Can I use 5W-30 instead of 0W-20? No. Toyota specifies 0W-20 full synthetic for the V35A-FTS. The twin turbocharger bearings and VVT-iE actuators are calibrated for 0W-20 cold-flow characteristics.
How often should I change the oil? Every 10000 miles or 12 months for normal driving. Use 5000 miles if towing regularly or operating in extreme conditions.
Last verified: 2026-04-14 | Source: 2024 Toyota Tundra Owner’s Manual