Complete Oil Specifications
Your 2024 Toyota Camry equipped with the 2.5L Dynamic Force engine (A25A-FKS) requires 0W-20 full synthetic oil meeting API SP and ILSAC GF-6A standards.
Quick Reference
| Specification | Value |
|---|---|
| Viscosity | 0W-20 |
| API Rating | API SP |
| ILSAC Rating | GF-6A |
| Capacity (with filter) | 4.5 quarts |
| Oil Filter | Toyota 04152-YZZA6 |
| Normal Interval | 10000 miles |
Why 0W-20 is Critical for This Engine
The A25A-FKS Dynamic Force engine achieves a 40% thermal efficiency rating through a high 13.0:1 compression ratio, D-4S dual injection, VVT-iW on the intake, and Toyota’s Atkinson-cycle combustion system. These high-efficiency technologies demand 0W-20 low-viscosity synthetic oil to minimize friction on the high-compression piston assembly during warm-up and to ensure immediate lubrication of the dual variable valve timing system from the first cold start of the day.
Using incorrect oil will:
- ❌ Increase friction during warm-up, reducing fuel efficiency
- ❌ Delay VVT-iW actuator response on cold starts
- ❌ Cause premature wear on the high-compression piston rings
Toyota-Approved Oil Brands
-
✅ Toyota Genuine Motor Oil 0W-20
-
✅ Mobil 1 Advanced Fuel Economy 0W-20
-
✅ Castrol Edge Extended Performance 0W-20
-
✅ Pennzoil Platinum Full Synthetic 0W-20
-
✅ Valvoline Advanced Full Synthetic 0W-20
Look for both the API SP donut and ILSAC GF-6A starburst on the container. GF-6A certification ensures the oil provides improved timing chain wear protection — important for the A25A-FKS’s lightweight chain system.
Severe Service Check
You need the 5000-mile interval if you:
- Make frequent short trips under 5 miles in cold weather
- Drive in heavy urban stop-and-go traffic daily
- Operate in extreme heat or extreme cold
- Use the Camry for rideshare or high-mileage commercial driving
Installation Details
Drain Plug Torque: 33 ft-lbs Replace the aluminum crush washer at every oil change — part number 90430-12031. Reusing the old washer frequently causes a slow drip at the drain plug.
OEM Filter: Toyota 04152-YZZA6
Aftermarket Filters:
-
Mobil 1 M1-110A
-
K&N HP-1017
-
Bosch 3330
Pro Tip: The A25A-FKS uses a cartridge-style oil filter canister on the front of the engine. A 64mm filter cup wrench is required for removal. Torque the canister cap to 18 ft-lbs. Pre-fill the cartridge with fresh 0W-20 before installing to reduce the brief dry-start interval after the oil change.
FAQs
What oil does a 2024 Toyota Camry 2.5L take? 0W-20 full synthetic meeting API SP and ILSAC GF-6A standards.
How many quarts does it need? 4.5 quarts with a new filter, 4.3 quarts without.
Can I use 0W-16 instead of 0W-20? No. 0W-16 is specified for the Camry Hybrid (A25A-FXS). The standard 2024 Camry with the A25A-FKS uses 0W-20.
Is synthetic oil required? Yes. The A25A-FKS is factory-filled with full synthetic and Toyota requires full synthetic for all oil changes.
How often should I change the oil? Every 10000 miles or 12 months for normal driving. Toyota’s Maintenance Reminder System alerts you based on actual driving conditions.
Last verified: 2026-03-25 | Source: 2024 Toyota Camry Owner’s Manual